S-25W single output switching power supply/SMPS

Protections: Short circuit/ Overload Cooling by free air convection 100% full load burn-in test Low cost, hogh reliability S-25-24 single output switching power supply/SMPS

ModelSpecification	S-25-5	S-25-12	S-25-15	S-25-24
DC output voltage	5V	12V	15V	24V
Output voltage error(Note 2)	±2%	±1%	±1%	±1%
Rated output current	5A	2.1A	1.7A	1.1A
Output current rage	0-5A	0-2.1A	0-1.7A	0-1.1A
Wave and noise(Note  3)	50mVp-p	100mVp-p	100mVp-p	100mVp-p
Inlet stability(Note  4)	±0.5%	±0.5%	±0.5%	±0.5%
Load stablity (Note  5)	±1%	±0.5%	±0.5%	±0.5%
DC output power	25W	25.2W	25.5W	26.4W
Efficiency	72%/115VAC	76%/115VAC	77%/115VAC	80%/115VAC
Adjustable range for DC voltage	+10,-5%	+10%	+10%	+10%
AC input voltage range	85-264VAC 47~63Hz;120~370VDC
Input current	0.6A/115V 0.35A/230A
AC INnrush current	Cold-start current15A/115V 30A/230V
Leakage current	<0.75mA/240VAC
Overload proctection	105%-150%Type,Foldback,current limiting reset ,auto recovery
Over-voltage protection	105%-135
High-temperature protection	…………
Temperature coefficient	±0.03%/°C(0-50°C)
Setup rise hold up time	800ms,50ms,10ms/115VAC 300ms,50ms,80ms/230VAC
Vibration	10-500Hz,2G 10min,/1cycle,Period for60min,Each axes
Withstand voltage	Input and output internal,1.5KVAC,Input and enclosure  1.5KVAC,Output and enclosure  0.5KVAC
Isolation resistance	Input and output internal Input and enclosure,Output and enclosure  500VDC/100MΩ
Working temperature and humidity	-10°C~+60°C(Refer to output derating curve),20%~90%RH
Store temperature and humidity	-20°C~+85°C.10%~95%RH
Overall dimension	99×97×35mm
Weight	0.3Kgs
Safety standards	UL1012 TUV EN6050(IEC950,UL1950)Approved
EMC standards	CISPR22(EN55022),IEC801-2,3,4,IEC555-2 Verification
Note1.The testing condition for the paramenter above is :230VAC input,rated load,25°C70% RH.Humidity.2.Error.include the setting error,line stability and load stability.(Note 5).3.Wave test:adopting "A12"double wire for 20MHz,and 0.1UF&47UF capacitor short-circuit for interrupting.4.Inlet voltage stability test:when is over load,the lowest voltage of inlet is up to the highest voltage.5.Load stability test:the load is from 0% to 100%. 6.C6must be knocked down.

S-25W single output switching power supply/SMPS